PLANET XGS3-24042 - Manual (Page 877)

45-22
[<hash-mask-length>] [<priority>]
Function:
This command is the candidate BSR configure command in global mode and is used to configure
PIM-SM information about candidate BSR in order to compete the BSR router with other candidate
BSRs. The command “no ipv6 pim bsr-candidate {vlan <vlan_id>| tunnel <tunnel-id>|<ifname>}
[<hash-mask-length>] [<priority>]” command disables the candidate BSR.
Parameter:
<vlan_id> is VLAN ID ,the value ranges from 1 to 4094;
<tunnel_id> is tunnel ID,the value ranges from 1 to 50;
<ifname> is the specified interface name;
[hash-mask-length] is the specified hash mask length. It’s used for the RP enable selection and
ranges from 0 to 32;
[priority] is the candidate BSR priority and ranges from 0 to 255. If this parameter is not configured,
the default priority value is 0.
Default:
This switch is not a candidate BSR router
Command Mode:
Global Mode
Usage Guide:
This command is the candidate BSR configure command in global mode and is used to configure
PIM-SM information about candidate BSR in order to compete the BSR router with other candidate
BSRs. Only this command is configured, this switch is the BSR candidate router.
Example:
Globally configure the interface vlan1 as the candidate BSR-message transmitting interface.
Switch (config)# ipv6 pim bsr-candidate vlan1 30 10
45.3.15 ipv6 pim cisco-register-checksum
Command:
ipv6 pim cisco-register-checksum [group-list <access-list name>]
no ipv6 pim cisco-register-checksum [group-list <access-list name>]
Function:
Configure the register packet’s checksum of the group specified by myfilter to use the whole
packet’s length.
Default:
Compute the checksum according to the register packet’s head length default: 8
Parameter: