PLANET XGS3-24042 - Manual (Page 502)

33-141
Related Command:
key
key-string
key chain
send-lifetime
33.2 address-family ipv4
Command:
address-family ipv4 vrf <vrf-name>
no address-family ipv4 vrf <vrf-name>
Function:
Configure this command to enable the routing message switching among VRF and enter the
address-family mode. The “no address-family ipv4 vrf <vrf-name>” command deletes the RIP
instances related to this VPN routing/forwarding instance.
Parameter:
<vrf-name> specifies the name of VPN routing/forwarding instances.
Command Mode:
router mode
Usage Guide:
This command is only used on PE router. A VPN routing/forwarding instance must be generated
with command ip vrf prior to using this command by which the VPN routing/forwarding instances
can be related to RIP instances.
Example:
Switch# config terminal
Switch(config)# router rip
Switch(config-router)# address-family ipv4 vrf VRF1
Switch(config-router-af)#
33.3 clear ip rip route
Command:
clear ip rip route {<A.B.C.D/M> | kernel | static | connected | rip | ospf | isis | bgp | all}
Function:
Clear specific route in the RIP route table.
Parameter: