PLANET XGS3-24042 - Manual (Page 1130)

69-4
Default:
Disabled.
Command Mode:
Admin Mode.
Example:
To enable debug switch of displaying local time synchronization information.
Switch# debug ntp sync
69.7 ntp access-group
Command:
ntp access-group server <acl>
no ntp access-group server <acl>
Function:
To configure/cancel the access control list of NTP Server.
Parameter:
<acl>: ACL number, range is from 1 to 99.
Default:
Not configure the access control of NTP Server.
Command Mode:
Global Mode.
Example:
To configure access control list 2 on the switch.
Switch(config)#ntp access-group server 2
69.8 ntp authenticate
Command:
ntp authenticate
no ntp authenticate
Function:
To enable/cancel NTP authentication function.
Default:
Disabled.
Command Mode: