PLANET XGS3-24042 - Manual (Page 904)

45-49
ipv6 multicast destination-control access-group <9000-10999>
no ipv6 multicast destination-control access-group <9000-10999>
Function:
Configure the IPv6 multicast destination control access list used by the port, the no operation of the
command will delete this configuration.
Parameters:
<9000-10999>: The destination control access list number.
Default:
Not configured.
Command Mode:
Port Configuration Mode.
Usage Guide:
This command can only take effect when the IPv6 multicast destination control is globally enabled,
after configuring this command, if the MLD-SNOOPING is enabled, when adding the port to the
multicast group, it will be matched according to the configured access list. Only when the port is
matched as permit, will it be added, or it can not be added.
Example:
switch(config)#inter ethernet 1/0/4
switch(Config-If-Ethernet1/0/4)#ipv6 multicast destination-control access-group 9000
switch(Config-If-Ethernet1/0/4)#
45.6.4 ipv6 multicast destination-control access-group
(sip)
Command:
ipv6 multicast destination-control <IPADDRESS/M> access-group <9000-10999>
no ipv6 multicast destination-control <IPADDRESS/M> access-group <9000-10999>
Function:
Configure multicast destination-control access-list used on specified net segment, the “no ipv6
multicast destination-control <IPADDRESS/M> access-group <9000-10999>“command deletes
this configuration.
Parameter:
<IPADDRESS/M>: IP address and mask length;
<9000-10999>: Destination control access-list number.
Command Mode:
Global Mode.