PLANET XGS3-24042 - Manual (Page 1105)

63-12
Default:
By default, disable receiving the flush packets of updating MAC address.
Command mode:
Port mode.
Usage Guide:
If this command is configured, then it will not receive the flush packets of updating MAC address.
Example:
Disable receiving the flush packets of updating MAC address.
Switch(config)# interface ethernet 1/0/1
Switch(config-If-Ethernet1/0/1)# ulpp flush disable mac
63.21 ulpp flush enable arp
Command:
ulpp flush enable arp
Function:
Enable receiving the flush packets of deleting ARP.
Default:
By default, disable receiving the flush packets of deleting ARP.
Command mode:
Port mode.
Usage Guide:
Enable this function to receive the flush packets which delete ARP.
Example:
Enable receiving of the flush packets of deleting ARP.
Switch(config)# interface ethernet 1/0/1
Switch(config-If-Ethernet1/0/1)# ulpp flush enable arp
63.22 ulpp flush enable mac
Command:
ulpp flush enable mac
Function:
Enable receiving the flush packets of updating MAC address.
Default: