PLANET XGS3-24042 - Manual (Page 773)

44-48
Example:
Switch#clear msdp statistics *
44.4.7 connect-source
Command:
connect-source <interface-type <interface-number>
no connect-source <interface-type> <interface-number>
Function:
To configure the interface address, which used for all the MSDP Peers to set up correspond
connection between MSDP Peer and MSDP.
Parameter:
<interface-type> <interface-number>: Interface type and interface number.
Command Mode:
MSDP Configuration Mode and MSDP Peer Configuration Mode.
Default:
There is no specified interface by default.
Usage Guide:
The router use the IP address of this port to set up MSDP Peer connection with MSDP Peer. Pay
attention: specified connect-source address must consitant with the configuration of Peer address,
otherwise can not set up TCP connection. The configuration under MSDP Peer mode will cover with
MSDP Mode. No command will cancel the configuration and set again all the MSDP connection of
this port.
Example:
Switch(config)#router msdp
Switch(router-msdp)#connect-source interface vlan 2
Switch(router-msdp)#peer 20.1.1.1
Switch(router-msdp-peer)# connect-source interface loopback 10
44.4.8 debug msdp all
Command:
debug msdp all
no debug msdp all
Function: