PLANET XGS3-24042 - Manual (Page 862)

45-7
Switch (Config -if-Vlan1)#ipv6 pim hello-holdtime 10
45.2.9 ipv6 pim hello-interval
Command:
ipv6 pim hello-interval < interval>
no ipv6 pim hello-interval
Function:
Configure interface PIM-DM hello message interval; the “no ipv6 pim hello-interval” command
restores default value.
Parameter:
<interval> is interval of periodically transmitted PIM-DM hello message, value range from 1s to
18724s.
Default:
Default interval of periodically transmitted PIM-DM hello message as 30s.
Command Mode:
Interface Configuration Mode
Usage Guide:
Hello message makes PIM-DM switch mutual location, and ensures neighbor ship. PIM-DM switch
announces existence itself by periodically transmitting hello messages to neighbors. If it doesn’t
receive hello messages from neighbors in regulation time, it confirms that the neighbors were lost.
Configuration time is not more than neighbor overtime. The command can configure on IPv6 tunnel
interface, but it is successful configuration to only configure tunnel carefully.
Example:
Configure PIM-DM hello interval on interface vlan1
Switch (config)#interface vlan1
Switch(Config-if-Vlan1)#ipv6 pim hello-interval 20
45.2.10 ipv6 pim multicast-routing
Command:
ipv6 pim multicast-routing
no ipv6 pim multicast-routing
Function:
Globally enable PIM-DM protocol; the “no ipv6 pim multicast-routing” command disenables
PIM-DM protocol.