PLANET XGS3-24042 - Manual (Page 1086)

62-1
Chapter 62 Commands for MRPP
62.1 control-vlan
Command:
control-vlan <vid>
no control-vlan
Function:
Configure control VLAN ID of MRPP ring; the “no control-vlan” command deletes control VLAN ID.
Parameter:
<vid> expresses control VLAN ID, the valid range is from 1 to 4094.
Command Mode:
MRPP ring mode
Usage Guide:
The command specifies Virtual VLAN ID of MRPP ring, currently it can be any value in 1-4094. To
avoid confusion, it is recommended that the ID is non-configured VLAN ID, and the same to MRPP
ring ID. In configuration of MRPP ring of the same MRPP loop switches, the control VLAN ID must
be the same, otherwise the whole MRPP loop may not be able to work normally or form broadcast.
The mrpp enable command must be start before the control-vlan command be used. If primary port,
secondary port, node-mode and enable commands all be configured after control-vlan, the mrpp-ring
function is enabled.
Example:
Configure control VLAN of mrpp ring 4000 is 4000.
Switch(config)#mrpp ring 4000
Switch(mrpp-ring-4000)#control-vlan 4000
62.2 clear mrpp statistics
Command:
clear mrpp statistics [<ring-id>]
Function:
Clear statistic information of MRPP data packet of MRPP ring receiving and transferring.
Parameter:
<ring-id> is MRPP ring ID, the valid range is from 1 to 4096, if not specified ID, it clears all of MRPP