PLANET XGS3-24042 - Manual (Page 325)

19-171
This command exists in other route protocol. When using this command, the information of other
related route protocol will be shown.
Example:
Show the related RIP instance information with VRF route/forwarding instance of IPI.
Switch# show ip vrf IPI
VRF IPI, FIB ID 1
Router ID: 11.1.1.1 (automatic)
Interfaces:
Vlan1
!
VRF IPI; (id=1); RIP enabled Interfaces:
Ethernet1/0/8
Name Interfaces
IPI Vlan1
Name Default RD Interfaces
IPI Vlan1
19.1.12 shutdown
Command:
shutdown
no shutdown
Function:
Shut down the specified VLAN interface of the switch. The no operation of the command will enable
the VLAN interface.
Command Mode:
VLAN Interface Configuration Mode.
Default:
The VLAN interface is enabled by default.
Usage Guide:
While shutting down the VLAN interface of the switch, it will not send data frames. If this interface
needs to obtain an IP address via BOOTP/DHCP protocol, it should be enabled.
Example:
Enable the VLAN1 interface of the switch.