PLANET XGS3-24042 - Manual (Page 567)

35-206
<ip-address> is the interface IP address shown in dotted decimal notation;
<time > is the dead interval length of the neighboring layer 3 switches, shown in seconds and
ranging between 1~65535.
Default:
The default dead interval is 40 seconds (normally 4 times of the hellow-interval).
Command Mode:
Interface Configuration Mode.
Usage Guide:
If no Hello data packet received after the dead-interval period then this layer 3 switch is considered
inaccessible and invalid. This command modifies the dead interval value of neighboring layer 3
switch according to the actual link state. The set dead-interval value is written into the Hello packet
and transmitted. To ensure the normal operation of the OSPF protocol, the dead-interval between
adjacent layer 3 switches should be in accordance or at least 4 times of the hello-interval value.
Example:
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip ospf dead-interval 80
35.31 ip ospf disable all
Command:
ip ospf disable all
no ip ospf disable all
Function:
Stop OSPF group process on the interface.
Command Mode:
Interface Configuration Mode.
Usage Guide:
This command resets the network area command and stops group process on specific interface.
Example:
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip ospf disable all