PLANET XGS3-24042 - Manual (Page 809)

44-84
Any Configuration Mode
Usage Guide:
The command applies to display DVMRP routing table item; DVMRP maintains individual unicast
routing table to check RPF.
Example:
Display DVMRP routiing.
Switch #show ip dvmrp route
Flags: N = New, D = DirectlyConnected, H = Holddown
Network Flags Nexthop Nexthop Metric Uptime Exptime
Xface Neighbor
10.1.35.0/24 .D. Vlan2 Directly Connected 1 00:11:16 00:00:00
13.1.1.0/24 .D. Vlan1 Directly Connected 1 00:10:22 00:00:00
Displayed Information Explanations
Network Target net segment or address and mask
Flags Routing state flag
Nexthop Xface Next hop interface address
Nexthop Neighbor Next hop neighbor
Metric Routing metric value
Uptime Routing uptime
Exptime Routing expire time
44.8 Commands for DCSCM
44.8.1 access-list (Multicast Destination Control)
Command:
access-list <6000-7999> {deny|permit} ip {{<source> <source-wildcard>}|{host
<source-host-ip>}|any-source} {{<destination> <destination-wildcard>}|{host-destination
<destination-host-ip>}|any-destination}
no access-list <6000-7999> {deny|permit} ip {{<source> <source-wildcard>}|{host
<source-host-ip>}|any} {{<destination> <destination-wildcard>}|{host-destination
<destination-host-ip>}|any-destination}
Function:
Configure destination control multicast access-list, the “no access-list <6000-7999> {deny|permit}
ip {{<source> <source-wildcard>}|{host <source-host-ip>}|any-source} {{<destination>