PLANET XGS3-24042 - Manual (Page 139)

XGS3 Command Guide
4-139
1000Mb port to be master mode; slave forces the 1000Mb port to be slave mode. force10g-full is the forced
10000Mbps speed at full-duplex mode.
Command mode:
Port Mode.
Default:
Auto-negotiation for speed and duplex mode is set by default.
Usage Guide:
This command is configures the port speed and duplex mode. When configuring port speed and duplex mode, the
speed and duplex mode must be the same as the setting of the remote end, i.e., if the remote device is set to
auto-negotiation, then auto-negotiation should be set at the local port. If the remote end is in forced mode, the same
should be set in the local end.
1000Gb ports are by default master when configuring nonegotiate mode. If one end is set to master mode, the other
end must be set to slave mode.
force1g-half is not supported yet.
Example:
Port 1 of SwitchA is connected to port 1 of SwitchB, the following will set both ports in forced 100Mbps at half-duplex
mode.
SwitchA(config)#interface ethernet1/0/1
SwitchA(Config-If-Ethernet1/0/1)#speed-duplex force100-half
SwitchB(config)#interface ethernet1/0/1
SwitchB(Config-If-Ethernet1/0/1)#speed-duplex force100-half
4.1.17 virtual-cable-test
Command:
virtual-cable-test
Function:
Test the link of the twisted pair cable connected to the Ethernet port. The response may include: well, short, open, fail.
If the test information is not well, the location of the error will be displayed (how many meters it is away from the
port).
Command mode:
Port Configuration Mode.
Default:
No link test.
Usage Guide:
The RJ-45 port connected with the twisted pair under test should be in accordance with the wiring sequence rules of
IEEE802.3, or the wire pairs in the test result may not be the actual ones. On a 100M port, only two pairs are used: (1,
2) and (3, 6), whose results are the only effective ones. If a 1000M port is connected to a 100M port, the results of (4,