PLANET XGS3-24042 - Manual (Page 131)

XGS3 Command Guide
4-131
Port 1 of Switch1 is connected to port 1 of Switch2, the following will disable the negotiation for both ports.
Switch1(config)#interface ethernet1/0/1
Switch1(Config-If-Ethernet1/0/1)#negotiation off
Switch2(config)#interface ethernet1/0/1
Switch2(Config-If-Ethernet1/0/1)#negotiation off
4.1.10 port-rate-statistics interval
Command:
port-rate-statistics interval [<interval-value>]
Function:
Set the interval of port-rate-statistics, ranging from 5 to 600.
Parameters:
interval-value: The interval of port-rate-statistics, unit is second, ranging from 5 to 600 with the configuration step of
5.
Command mode:
Global Mode.
Default:
Only port-rate-statistics of 5 seconds and 5 minutes are displayed.
Example:
Count the interval of port-rate-statistics as 20 seconds.
Switch(config)# port-rate-statistics interval 20
4.1.11 port-scan-mode
Command:
port-scan-mode {interrupt | poll}
no port-scan-mode
Function:
Configure the scan mode of the port as “interrupt” or “poll”, the no command restores the default scan mode.
Parameters:
interrupt: the interrupt mode; poll: the poll mode.
Command mode:
Global Mode.
Default:
Poll mode.
Usage Guide: