PLANET XGS3-24042 - Manual (Page 859)

45-4
45.2.4 ipv6 pim bsr-border
Command:
ipv6 pim bsr-border
no ipv6 pim bsr-border
Function:
To configure or delete PIM6 BSR-BORDER interface.
Default:
Non-BSR-BORDER.
Command Mode:
Interface Configuration Mode.
Usage Guide:
To configure the interface as the BSR-BORDER. If configured, BSR related messages will not
receive from or sent to the specified interface. All the networks connected to the interface will be
considered as directly connected.
Example:
Switch(Config-if-Vlan1)#ipv6 pim bsr-border
45.2.5 ipv6 pim dense-mode
Command:
ipv6 pim dense-mode
no ipv6 pim dense-mode
Function:
Enable PIM-DM protocol on interface; the “no ipv6 pim dense-mode” command disenables
PIM-DM protocol on interface.
Default:
Disable PIM-DM protocol
Command Mode:
Interface Configure Mode
Usage Guide:
The command will be taken effect, executing ipv6 multicast-routing in Global Mode. Don’t support
multicast protocol mutual operation, namely can’t synchronously enable dense mode and sparse
mode in one switch. The command can configure on IPv6 tunnel interface, but it is successful
configuration to only configure tunnel carefully.
Example:
Enable PIM-DM protocol on interface vlan1.