PLANET XGS3-24042 - Manual (Page 1106)

63-13
By default, disable receiving the flush packets of updating MAC address.
Command mode:
Port mode.
Usage Guide:
Enable receiving the flush packets of updating MAC address table.
Example:
Enable receiving the flush packets of updating the MAC address.
Switch(config)# interface ethernet 1/0/1
Switch(config-If-Ethernet1/0/1)# ulpp flush enable mac
63.23 ulpp group
Command:
ulpp group <integer>
no ulpp group <integer>
Function:
Create a ULPP group. If this group exists, then enter the configuration mode of ULPP group. The no
command deletes a ULPP group.
Parameter:
<integer> is the ID of ULPP group, range from 1 to 48.
Command mode:
Global Mode.
Default:
Any ULPP groups are not configured.
Example:
Configure ulpp group 20 or enter the mode of ulpp group 20.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)#
63.24 ulpp group master
Command:
ulpp group <integer> master
no ulpp group <integer> master
Function: