PLANET XGS3-24042 - Manual (Page 1175)

75-5
75.2 mpls enable
Command:
mpls enable
no mpls enable
Function:
Enable mpls protocol; the no command will disable the protocol.
Default:
The mpls protocol is disabled by default.
Command Mode:
Global Mode.
Usage Guide:
Implementing this command will enable the mpls protocol.
Example:
Switch(config)#mpls enable
75.3 mpls ingress-ttl
Command:
mpls ingress-ttl <0-255>
no mpls ingress-ttl
Function:
Set the TTL value of IP messages through the ingress LSR of LSP; the no operation will cancel the
configured value.
Parameters:
<0-255>: the TTL value.
Command Mode:
Global Mode
Usage Guide:
The ingress-ttl configuration of the ingress LSR will be the TTL value in the top label of all MPLS
messages entering this LSP through the LSP ingress router.
Example:
Set the ingress TTL as 45.
Switch#config terminal
Switch(config)#mpls ingress-ttl 45
Related Commands: