PLANET XGS3-24042 - Manual (Page 442)

29-81
which <subscriber-id> is the content of subscriber-id in user-defined option 38 and it is a string with
a length of less than 128. The no operation of this command restores subscriber-id in option 38 to
vlan name together with port name such as "Vlan2+Ethernet1/0/2".
Parameters:
subscriber-id, user-defined content of option 38
Default:
Set subscriber-id in option 38 to vlan name together with port name.
Command Mode:
Port mode
Usage Guide:
Because option 38 information added by switch may associate with third-party DHCPv6 servers,
users can specify subscriber-id content based on server condition when standard subscriber-id of
the switch cannot satisfy the demand of server. The vlan name together with physical port name is
used as subscriber-id in option 38 by default.
Example:
Enable abc as subscriber-id of DHCPv6 option 38.
Switch(Config-if-Ethernet1/0/1)#ipv6 dhcp snooping subscriber-id abc
29.1.16 ipv6 dhcp snooping subscriber-id option
Command:
ipv6 dhcp snooping subscriber-id option
no ipv6 dhcp snooping subscriber-id option
Function:
This command enables DHCPv6 SNOOPING to support option 38, the no form of this command
disables it.
Default:
Disable option 38 of DHCPv6 SNOOPING.
Command Mode:
Global configuration mode
Usage Guide:
Only after this command is configured, DHCPv6 SNOOPING can add option 38 in DHCPv6 packets
before sending it to server or relay agent. Make sure that DHCPv6 SNOOPING has been enabled
before executing this command. The system disables option 38 of DHCPv6 SNOOPING by default.
Example:
Enable option 38 in DHCPv6 SNOOPING.
Switch(Config)#ipv6 dhcp snooping enable