PLANET XGS3-24042 - Manual (Page 669)

37-308
neighbor {<ip-address>|<TAG>} soft-reconfiguration inbound
no neighbor {<ip-address>|<TAG>} soft-reconfiguration inbound
Function:
Configures whether perform inbound soft reconfiguration; the “no neighbor {<ip-address>|<TAG>}
soft-reconfiguration inbound” command set to not perform the inbound soft reconfiguration.
Parameter:
<ip-address>: Neighbor IP address
<TAG>: Name of peer group
Default:
Not perform inbound soft reconfiguration.
Command Mode:
The system saves the inbound messages in the buffer after the soft reconfiguration is set, will
applies as soon as it restarts so to reduce consumptions of switching with other routers. The
command is only available when the route refresh capability is not enabled
Example:
Switch(config-router)#neighbor 11.1.1.120 soft-reconfiguration inbound
37.74 neighbor soo
Command:
neighbor <ip-addr> soo <soo-val>
no neighbor <ip-addr> soo <soo-val>
Function:
Configure the origin source from the neighbor route, the no command will delete the configuration.
Parameters:
<ip-addr> The neighbor IP address show in dotted decimal notation.
<soo-val> is the origin source ,which the format is <AA:NN>, AA is AS number, ranging from 1 to
4294967295, it can be shown in decimal notation (such as 6553700) or delimiter method (such as
100.100), NN is a random two byte number.
Command Mode:
VRF address family mode
Usage Guide:
If the user AS connects with several ISP devices, to avoid the user route returns to itself through P
area, this attribute can be set. Once this attribute is set, it spreads with route. Routes carrying SOO
attributes will not be spreader to a neighbor configured with the attribute.
Example: