PLANET XGS3-24042 - Manual (Page 719)

41-11
41.17 ipv6 route bfd
Command:
ipv6 route {vrf <name> <ipv6-address> | <ipv6-address>} prefix <nexthop> bfd
no ipv6 route {vrf <name> <ipv6-address>|<ipv6-address>} prefix <nexthop> bfd
Function:
Configure BFD for the static IPv6 route, no command cancels the configuration.
Parameter:
<name> is vrf name, <ipv6-address> is destination address, prefix is prefix length, vlanid is output
interface, nexthop is nexthop address.
Default:
BFD is not configured for the static IPv6 route.
Command Mode:
Global mode
Usage Guide:
Configure BFD for the route and specify the detection mode.
Example:
Configure BFD for the static IPv6 route.
s3(config)#ipv6 route 3000::/64 2010::1 bfd
41.18 neighbor
Command:
neighbor {<ipv6-address> | <ipv4-address>} bfd
no neighbor {<ipv6-address> | <ipv4-address>}bfd
Function:
Enable link detection offered by BFD on the peer neighbor of BGP(4+), no command cancels the
configuration.
Parameter:
<ipv4-address> is IPv4 address
<ipv6-address> is IPv6 address
The validity of parameter should be ensured by users and do not check the validity of address.
Default:
BFD is not enabled for BGP(4+).
Command Mode:
BGP(4+) route configuration mode