PLANET XGS3-24042 - Manual (Page 1158)

72-14
72.13 show logging buffered
Command:
show logging buffered [level {critical | warnings} | range <begin-index> <end-index>]
Function:
This command displays the detailed information in the log buffer channel. This command is not
supported on low end switches.
Parameter:
level {critical | warnings} means the level of critical information. <begin-index> is the index start
value of the log message, the valid range is 1-65535, <end-index> is the index end value of the log
message, and the valid range is 1-65535. When only display logging buffered information of the line
card must be added range parameter, but the main control has not the request.
Command Mode:
Admin and Configuration Mode.
Default:
No parameter specified indicates all the critical log information will be displayed.
Usage Guide:
Warning and critical log information is saved in the buffer zone. When displayed to the terminal,
their display format should be: index ID time <level> module ID [mission name] log information.
Example 1:
Display the critical log information in the log buffer zone channel and related to the main control with
index ID between 940 and 946.
Switch#show logging buffered level critical range 940 946
Example 2:
Display all the information which level is warning in the log buffer zone channel.
Switch#show logging buffered level warning
72.14 show logging executed-commands state
Command:
show logging executed-commands state
Function:
Show the state of logging executed-commands.
Command Mode: