PLANET XGS3-24042 - Manual (Page 965)

48-1
Chapter 48 Commands for 802.1x
48.1 debug dot1x detail
Command:
debug dot1x detail {pkt-send | pkt-receive | internal | all | userbased | webbased} interface
[ethernet] <interface-name>
no debug dot1x detail { pkt-send | pkt-receive | internal | all | userbased | webbased}
interface [ethernet] <interface-name>
Function:
Enable the debug information of dot1x details; the no operation of this command will disable that
debug information.
Parameters:
pkt-send: Enable the debug information of dot1x about sending packets;
pkt-receive: Enable the debug information of dot1x about receiving packets;
internal: Enable the debug information of dot1x about internal details;
all: Enable the debug information of dot1x about all details mentioned above;
userbased: user-based authentication;
webbased: Web-based authentication;
<interface-name>: the name of the interface.
Command Mode:
Admin Mode.
Usage Guide:
By enabling the debug information of dot1x details, users can check the detailed processes of the
Radius protocol operation, which might help diagnose the cause of faults if there is any.
Example:
Enable all debug information of dot1x details on interface1/0/1.
Switch#debug dot1x detail all interface ethernet1/0/1
48.2 debug dot1x error
Command:
debug dot1x error
no debug dot1x error
Function: