PLANET XGS3-24042 - Manual (Page 664)

37-303
Configure the BGP neighbor. The no command is used for deleting BGP neighbors.
Parameter:
<ip-address>: Neighbor IP address
<TAG>: Name of peer group
<as-id>: Neighbor AS number, ranging from 1 to 4294967295, it can be shown in decimal notation
(such as 6553700) or delimiter method (such as 100.100).
Default:
No neighbors
Command Mode:
BGP route mode and address-family mode
Usage Guide:
The BGP neighbors are completely generated through command configurations. A neighbor
relationship can only be really established by mutual configuring. Partner AS number should be
specified in configuration. The neighbor relationship can not be established when the AS number is
incorrect. The partner AS number is the same with that of local side inside the AS.
Example:
Configure 2 neighbor AS as 100 and 100.200.
Switch(config)#router bgp 200
Switch(config-router)# neighbor 10.1.1.64 remote-as 100
Switch(config-router)# neighbor 10.2.1.64 remote-as 100.200
37.67 neighbor remove-private-AS
Command:
neighbor {<ip-address>|<TAG>} remove-private-AS
no neighbor {<ip-address>|<TAG>} remove-private-AS
Function:
Configures whether remove the private AS number when sending to the neighbor.The “no
neighbor {<ip-address>|<TAG>} remove-private-AS” command cancels this configuration.
Parameter:
<ip-address>: Neighbor IP address
<TAG>: Name of peer group
Default:
Not configured
Command Mode:
BGP route mode and address-family mode
Usage Guide: