PLANET XGS3-24042 - Manual (Page 333)

19-179
length of IPv6 address, which is between 3-128, eui-64 means IPv6 address is generated
automatically based on eui64 interface identifier of the interface.
Command Mode:
Interface Configuration Mode.
Usage Guide:
IPv6 address prefix can not be multicast address or any other specific IPv6 address, and different
layer 3 interfaces can not configure the same address prefix. For global unicast address, the length
of the prefix must be greater than or equal to 3. For site-local address and link-local address, the
length of the prefix must be greater than or equal to 10. For interface loopback port, the length of the
prefix must be equaled to 128.
Example:
Configure an IPv6 address on VLAN1 Layer 3 interface: the prefix is 2001:3f:ed8::99 and the length
of the prefix is 64.
Switch(Config-if-Vlan1)#ipv6 address 2001:3f:ed8::99/64
19.2.13 ipv6 route
Command:
ipv6 route <ipv6-prefix | prefix-length> {<ipv6address> | <interface-type interface-number> |
{<ipv6address> <interface-type interface-number>} | tunnel <tunnel no> } [<precedence>]
no ipv6 route <ipv6-prefix | prefix-length> {<ipv6address> | <interface-type
interface-number> | {<ipv6address> <interface-type interface-number>} | tunnel <tunnel no> }
[<precedence>]
Function:
Set IPv6 static route.
Parameters:
Parameter <ipv6-prefix> is the destination prefix of IPv6 static route, parameter <prefix-length> is
the length of IPv6 prefix, parameter <ipv6-address> is the next hop IPv6 address of the reachable
network, parameter <interface-type interface-number> is the name of interface from which to
reach the destination, <tunnel no> is the output tunnel number of the tunnel route, parameter
<precedence> is the weight of this route, the range is 1-255, the default is 1
Default:
There is not any IPv6 static route which is configured by default.
Command Mode:
Global Mode
Usage Guide:
When the next hop IPv6 address is link-local address, the interface name must be specified. When