3 monitor session destination interface, Monitor session destination interface – PLANET XGS3-24042 User Manual

Page 1113

Advertising
background image

65-5

Specify the access control for the source of the mirror. The no form command will disable this

configuration.

Parameters:

<session> is the session number for the mirror. Currently 1 to 7 is supported. <interface-list> is

the list of source interfaces of the mirror which can be separated by '-' and ';'. <num> is the number

of the access list. rx means to filter the datagram received by the interface. tx for the datagram sent

out, and both means both of income and outcome datagram.

Command Mode:

Global Mode.

Usage Guide:

This command is used to configure the source interfaces for the mirror. It is not restricted the source

interface of the mirror on the switch. The source can be one interface, or can be multiple interfaces.

For flow mirror, only datagram received can be mirrored. The parameters can be rx, tx, both. The

related access list should be prepared before this command is issued. For how to configure the

access list, please refer to ACL configuration. The mirror can only be created after the destination

interface of the corresponding session has been configured.

Example:

Configure the mirror interface 1/0/6 to filter with access list 120 in session 2.

Switch(config)#monitor session 2 source interface 1/0/6 access-list 120 rx

65.3 monitor session destination interface

Command:

monitor session <session> destination interface <interface-number>

no monitor session <session> destination interface <interface-number>

Function:

Specify the destination interface of the mirror. The no form command will disable this configuration.

Parameters:

<session> is the session number of the mirror, which is currently limited to 1-7.

<interface-number> is the destination interface of the mirror.

Command Mode:

Global mode

Usage Guide:

7 destination mirror interface is supported on the switch. To be mentioned. The interface which is

configured as the destination of the mirror should not be configured as the member of the interface

trunk. And the maximum throughput of the interface is recommended to be larger than the total

Advertising
This manual is related to the following products: