PLANET XGS3-24042 - Manual (Page 112)

XGS3 Command Guide
3-112
Usage Guide：
After enabling this command on a commander switch, candidate switches will be automatically added as members.
Example:
Enable the auto adding function in the commander switch.
Switch(config)#cluster auto-add
3.3 cluster commander
Command:
cluster commander [<cluster-name>]
no cluster commander
Function:
Set the switch as a commander switch, and create a cluster.
Parameter:
<cluster-name> is the cluster’s name, no longer than 32 characters.
Command mode:
Global Mode
Default:
Default setting is no commander switch. cluster_name is null by default.
Usage Guide:
This command sets the role of a switch as commander switch and creates a cluster, which can only be executed on
non commander switches. The cluster_name cannot be changed after the switch becoming a commander, and “no
cluster commander” should be executed first to do that. The no operation of this command will cancel the
commander configuration of the switch.
Example:
Set the current switch as the commander switch and name the cluster as switch.
Switch(config)#cluster commander switch
3.4 cluster ip-pool
Command:
cluster ip-pool <commander-ip>
no cluster ip-pool
Function:
Configure private IP address pool for member switches of the cluster.
Parameters：