PLANET XGS3-24042 - Manual (Page 573)

35-212
no ip ospf [<ip-address>] transmit-delay
Function:
Set the transmit delay value of LSA transmitting; the “no ip ospf [<ip-address>] transmit-delay”
restores the default value.
Parameter:
<ip-address> is the interface IP address show in dotted decimal notation.
<time> is the transmit delay value of link state announcements between the interface and adjacent
layer 3 switches, shown in seconds ang raning between 1～65535.
Default:
Default transmit delay value of link state announcements is 1 second.
Command Mode:
Interface Configuration Mode.
Usage Guide:
The LSA ages with time in the layer 3 switches, but not in the network transmitting process. By
adding the transit-delay prior to sending the LSA, the LSA will be sent before aged.
Example:
Set the LSA transmit delay of interface vlan1 to 3 seconds.
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip ospf transmit-delay 3
35.40 key
Command:
key <keyid>
no key <keyid>
Function:
This command is for managing and adding keys in the key chain. The “no key <keyid>” command
deletes one key.
Parameter:
<keyid> is key ID, ranging between 0-2147483647.
Command Mode:
keychain Mode and keychain-key Mode
Usage Guide:
The command permits entering the keychain-key mode and set the passwords corresponding to the
keys.
Example: