PLANET XGS3-24042 - Manual (Page 1179)

75-9
Display detailed information of public network FTN router created by MPLS on the switch.
Command Mode:
Admin and Config mode.
Usage Guide:
Implementing this command will display detailed information of public network FTN routers created
by MPLS on the switch.
Example:
Switch#show mpls ftn-table detail
---------------------------------------------
FTN ID : 1
VrfIndex : 0
Fec : 100.1.1.0/24
Nexthop addr : 0.0.0.0
Owner : LDP
Primary : Yes
Row Status : Active
Exp-bits : 0X0
Incoming DSCP : none
Tunnel ID : 0
Protected LSP id : 0
QoS Resource id : 0
In-Label : 0
In-Interface : N/A
Out-Label : 3
Out-Interface : Vlan10
Admin Status : Up
Oper Status : Up
Oper Code : Push
Display Explanation
FTN ID The FEC ID
VrfIndex The Vrf Index
Fec The Fec Address
Nexthop addr The next-hop address
Owner The protocol creating the cross-link table
Primary Whether it is primary or not.
Row Status The Row status
Exp-bits The experiment bits