PLANET XGS3-24042 - Manual (Page 759)

44-34
ip pim register-rp-reachability
no ip pim register-rp-reachability
Function:
This command makes DR check the RP reachability in the process of registration.
Default:
Do not check
Command Mode:
Global Mode
Usage Guide:
This command configures DR whether or not to check the RP reachability.
Example:
Configure DR to check the RP reachability.
Switch (config)#ip pim register-rp-reachability
Switch (config)#
44.3.26 ip pim register-source
Command:
ip pim register-source {<A.B.C.D> | <ifname>| vlan <vlan-id>}
no ip pim register-source
Function:
This command is to configure the source address of register packets sent by DR to overwrite default
source address. This default source address is usually the RPF neighbor of source host direction.
Parameter:
<ifname> is the interface name,
<vlan-id> is VLAN ID;
<A.B.C.D> is the configured source IP addresses.
Default:
Do not check
Command Mode:
Global Mode
Usage Guide:
The “no ip pim register-source” command restores the default value, no more parameter is
needed. Configured address must be reachable to Register-Stop messages sent by RP. It’s usually
a circle address, but it can be other physical addresses. This address must be announcable through
unicast router protocols of DR.
Example: