PLANET XGS3-24042 - Manual (Page 163)

8-9
Usage Guide:
After configuring the interval of sending messages, LLDP messages can only be received after a
period as long as configured. The interval should be less than or equal with half of aging time, for a
too long interval will cause the state of being aged and reconstruction happen too often; while a too
short interval will increase the flow of the network and decrease the bandwidth of the port. The value
of the aging time of messages is the product of the multiplier and the interval of sending messages.
The maximum aging time is 65535 seconds.
When tx-interval is the default value and transmit delay is configured via some commands,
tx-interval will become four times of the latter, instead of the default 40.
Example:
Set the interval of sending messages as 40 seconds.
Switch(config)# lldp tx-interval 40
8.15 show debugging lldp
Command:
show debugging lldp
Function:
Display all ports with lldp debug enabled.
Command Mode:
Admin and Configuration Mode.
Usage Guide:
With show debugging lldp, all ports with lldp debug enabled will be displayed.
Example:
Display all ports with lldp debug enabled.
Switch(config)#show debugging lldp
====BEGINNING OF LLDP DEBUG SETTINGS====
debug lldp
debug lldp packets interface Ethernet1/0/1
debug lldp packets interface Ethernet1/0/2
debug lldp packets interface Ethernet1/0/3
debug lldp packets interface Ethernet1/0/4
debug lldp packets interface Ethernet1/0/5
=============END OF DEBUG SETTINGS===============