Lenze 8400 StateLine - Manual (Page 141)

Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
141
5 Motor control (MCTRL)
5.4 V/f characteristic control (VFCplus)
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Tip!
Cases of application for this function:
• Operation of reluctance motors or synchronous motors during controlled acceleration
(reduction of natural frequencies caused by wrong excitation).
• Adaptation of the voltage requirement for the motor, depending on specific load
conditions.

Proceed as follows to open the dialog for parameterising the motor control:
1. »Engineer« Go to the Project view and select the 8400 StateLine controller.
2. Select the Application parameters tab from the Workspace.
3. Select the motor control "10: VFCplus: V/f definable" from the Overview dialog box in the
Motor control list field:
4. Click the Motor control V/f definable button to change to the Overview  Motor control V/f
dialog box.
• This dialog level only shows a simplified signal flow with the most important
parameters.
• When you click the >>More details button in the left-most position, a signal flow with
more details/parameters is displayed.