Lenze 8400 StateLine - Manual (Page 23)

Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
23
2 Introduction: Parameterising the controller
2.1 Integrated technology applications
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.1.1 Purpose of the technology applications
The stepped Inverter Drives 8400 series provides solutions for simple to complex applications –
depending on the user's experience and knowledge about the handling of drives and drive tasks.
On the one hand, a great scope of standard drive tasks for frequency inverters is covered by the
technology applications offered by Lenze, and on the other hand, the user is relieved from time-
consuming programming activities. In practice, some drive tasks are alike so that minor
modifications of the corresponding technology applications lead to quick results.
Other important features of technology applications are:
• Direct implementation of drive tasks without recreating a function block interconnection inside
the device
• Operation via keypad and/or operation via convenient operator dialogs in the «Engineer».
• Commissioning via few operating and diagnosing parameters (local keypad operation).
• Achieving a transparency as high as possible via the integrated functionality of the device by
representing signal flow diagrams.
• Provision of a basic functionality suitable and often sufficient for many applications.
2.1.2 Application cases for a technology application
You should use a technology application if
• the task can be solved completely or to a great extent by the basic functionality of the
technology application.
• the end customer does not want to create the comprehensive core functions of the
corresponding technology on his own.
• the creation time for a project is to be reduced by using the ready-made technology application
• the end customer wants to build upon the know-how of Lenze.

Tip!
If the end customer of the machine does not want to use ready-made Lenze functions, it is
also possible to implement individual drive solutions with the "StateLine C", "HighLine C"
and "TopLine C" versions in the form of "free interconnections". (In case of "StateLine C2,
free interconnection is only possible from version 12.00.00 and »Engineer« V2.17.)
Here, a technology application can be used as starting basis, which has to be adapted to the
requirement by a change or extension via function block editor (see the following chapter).