Lenze 8400 StateLine - Manual (Page 817)

Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
817
15 Parameter reference
15.2 Parameter list | C02314
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C02314
C02315
C02580
Parameter | Name:
C02314 | Reserved
Data type: UNSIGNED_8
Index: 22261
d
= 56F5
h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C02315 | LS_WriteParamList: Manual entry of motor type
Data type: UNSIGNED_8
Index: 22260
d
= 56F4
h
From version 14.00.00 onwards : Parameter values (1st value ... 4th value) for optional motor data change-over
Selection list
0 Automatic
1 ASM
2 PSM
Subcodes Lenze setting Info
C02315/1 0: Automatic LS_WriteParamList : c1001_s1_val1
C02315/2 0: Automatic LS_WriteParamList : c1001_s1_val2
C02315/3 0: Automatic LS_WriteParamList : c1001_s1_val3
C02315/4 0: Automatic LS_WriteParamList : c1001_s1_val4
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C02580 | Holding brake: Operating mode
Data type: UNSIGNED_8
Index: 21995
d
= 55EB
h
Selection of the operating mode for holding brake control
 Holding brake control
Selection list (Lenze setting printed in bold) Info
0 Brake control off No holding brake is used. Internal control is switched off.
11 Manually controlled The holding brake is released and closed via a control bit
in the MCK control word.
12 Autom. controlled The holding brake is automatically released and closed
via speed setpoint comparisons.
13 Semi-automat. controlled From version 11.00.00
The holding brake is released and closed via a control bit
in the MCK control word.
• In contrast to the manual operation (mode 11)
• the feedforward control is active in this mode,
preventing a sagging e.g. in case of a hoist.
• the brake in this mode also closes when the
controller is inhibited in order to prevent the axis in
a hoist from falling.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1