Lenze 8400 StateLine - Manual (Page 722)

15 Parameter reference
15.2 Parameter list | C00622
722
Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00622
C00632
Parameter | Name:
C00622 | System connection list: Angle
Data type: UNSIGNED_16
Index: 23953
d
= 5D91
h
Connection parameters: 32-bit inputs
• Selection of the 32-bit output signals for connection with the 32-bit input signals.
• The selection list contains all 32-bit output signals which can be assigned to the 32-bit inputs mapped by the
subcodes.
• Non-listed subcodes are "reserved".
Selection list
See
selection list - angle signals
Subcodes Lenze setting Info
C00622/9 0: Not connected LP_CanOut1 : dnOut34_p
CAN1 output: Data words 3 + 4
C00622/10 0: Not connected LP_CanOut2 : dnOut34_p
CAN2 output: Data words 3 + 4
C00622/11 0: Not connected LP_CanOut3 : dnOut34_p
CAN3 output: Data words 3 + 4
C00622/12 0: Not connected LP_MciOut : dnOut34_p
MCI output: Data words 3 + 4
C00622/13 0: Not connected LS_DigitalInput : dnPosIn12_Set_p
Frequency input DI1/DI2: Starting value for angle
integrator
C00622/25 0: Not connected LP_CanOut4 : dnOut34_p
CAN4 output: Data words 3 + 4
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00632 | L_NSet_1: Max.SkipFrq.
Data type: INTEGER_16
Index: 23943
d
= 5D87
h
Maximum limit values for the speed blocking zones
• Selection of the maximum limit values for the blocking zones in which the speed must not be constant.
Setting range (min. value | unit | max. value)
0.00 % 199.99
Subcodes Lenze setting Info
C00632/1 0.00 % L_NSet_1 : Blocking speed1 max
C00632/2 0.00 % L_NSet_1 : Blocking speed2 max
C00632/3 0.00 % L_NSet_1 : Blocking speed3 max
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100