Lenze 8400 StateLine - Manual (Page 39)

Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
39
2 Introduction: Parameterising the controller
2.4 Device access protection
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Short overview of the relevant parameters for configuring the password protection:
When the password is set, the respective restriction is active if the corresponding bit has been set:
The parameter set must be saved to the device safe against mains failure to prevent password
protection configured in the device from getting lost due to mains switching.
 Save parameter settings in the memory module safe against mains failure ( 32)
Parameter Info Lenze setting
C00506/1 PW protection internal config 0x0007
Bit 0 Only access to user menu
• The menus in the keypad are reduced.
• Only the user menu can be used to change
parameters.
Bit 1 Parameter write protection
• System blocks cannot be used to write into
write/read parameters.
Bit 2 Parameter read protection
• System blocks cannot be used to read write/read
parameters.
Bit 3 ... 15 Reserved
C00508/1 PW protection config. X6 (DIAG) 0x0006
Bit 0 Reserved
Bit 1 Parameter write protection
• The diagnostics interface X6 cannot be used to
write into write/read parameters.
Bit 2 Parameter read protection
• The diagnostics interface X6 cannot be used to
read write/read parameters.
Bit 3 ... 15 Reserved
C00509/1 PW protection config. X1 (CAN) 0x0006
Bit 0 Reserved
Bit 1 Parameter write protection
• The CANopen interface X1 cannot be used to
write into write/read parameters.
Bit 2 Parameter read protection
• The CANopen interface X1 cannot be used to read
write/read parameters.
Bit 3 ... 15 Reserved
C00510/1 PW protection config. MCI 0x0006
Bit 0 Reserved
Bit 1 Parameter write protection
• The fieldbus interface (MCI) cannot be used to
write into write/read parameters.
Bit 2 Parameter read protection
• The fieldbus interface (MCI) cannot be used to
read write/read parameters.
Bit 3 ... 15 Reserved