Lenze 8400 StateLine - Manual (Page 30)

2 Introduction: Parameterising the controller
2.3 General notes on parameters
30
Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
General operation
[2-2] Example: Changing parameters with the keypad
Multilingualism
All texts displayed in the keypad are in English.
From version 11.00.00 onwards, the most important menus as well as diagnostic and configuration
parameters can are also available in German and French. To set a different language, select the
Language selection menu item in the main menu of the keypad.
1. Use the / navigation keys to select the
desired menu.
• Use the / navigation keys to reach a
higher/lower menu level.
• Use the  function key to return to the
main menu.
2. Use the / navigation keys to select the
parameter to be set within a submenu.
3. In order to select another subcode in case of a
parameter with subcodes:
• Press the navigation key  to change tot he
editing mode for the subcode.
• Use the navigation keys to set the desired
subcode.
4. Use the  function key to switch over to the
editing mode.
5. Use the navigation keys to set the desired value.
6. Use the  function key to accept the change
and to leave the editing mode.
• Use the  function key to leave the editing
mode without accepting the change.
Load Lenze setting
C00002/001
Off / Finished
EDIT
Par1 8400 StateLine C
SAVE
Code list
Go To Param
USER - Menu
Fixed setpoint 1
C00039/001
40.00 %
EDIT
Fixed setpoint 2
60.00 %
EDIT
C00039/00 2
Fixed setpoint 2
C00039/002
ESC
6 0.00 %
OK
1.
2.
3.
5.
4.
6.
• The multilingual texts are stored in the
controller and do not have to be loaded into the
device.
• For reasons of disc space, only the most
important menus and parameters as well as the
error messages are available in several
languages.
Language
ESC
Français
Deutsch
English
OK