Lenze 8400 StateLine - Manual (Page 426)

9 Diagnostics & error management
9.4 Drive diagnostics via keypad/bus system
426
Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
9.4 Drive diagnostics via keypad/bus system
Keypad display of the controller status
• If the keypad on the front of the controller is connected to the
diagnostic interface X6, the status of the controller is shown
via different icons on the LCD display in the area .
Icon Meaning Note
 Controller is switched on.  SwitchedOn ( 90)
 Controller is enabled.
 Application in the controller is stopped.
 Quick stop active
 Controller is inhibited. The power outputs are inhibited.
 Controller is ready to start.  ReadyToSwitchOn ( 89)
 Speed controller 1 at the limit. The drive is torque-controlled.
 Set current limit has been exceeded in motor
or generator mode.
 Pulse inhibit active The power outputs are inhibited.
 System fault active
 Fault  Fault ( 94)
 Trouble  Trouble ( 93)
 TroubleQSP  TroubleQSP ( 92)
 Warning is active