Lenze 8400 StateLine - Manual (Page 228)

5 Motor control (MCTRL)
5.11 Braking operation/brake energy management
228
Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Proceed as follows to open the dialog for parameterising the brake energy management:
1. »Engineer« Go to the Project view and select the 8400 StateLine controller.
2. Select the Application parameters tab from the Workspace.
3. Go to the Overview dialog level and click the "basic functions" button.
4. Go to the Overview  basic functions dialog box and click the Brake energy management
button.
Short overview of the relevant parameters:
Parameter Info Lenze setting
Value Unit
C00173 Mains voltage 3ph 400 V / 1ph 230 V
C00175 Brake energy management R_Brake (brake resistance)
Brake resistor
C00133 Brake resistor utilisation - %
C00129 Brake resistance value 39.0 Ohm
C00130 Rated brake resistor power 100 W
C00131 Thermal capacity - brake resistor 10.0 kWs
C00174 Reduced brake chopper threshold 0 V
C00572 Threshold - brake resist. overload 100 %
C00574 Resp. to brake resist. overtemp. No response
Inverter motor brake
C00987 Inverter motor brake: nAdd 80 rpm
C00988 Inverter motor brake: PT1 filter time 0.0 ms
Highlighted in grey = display parameter