Lenze 8400 StateLine - Manual (Page 31)

Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
31
2 Introduction: Parameterising the controller
2.3 General notes on parameters
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.3.2 Change parameter settings with PC and Lenze software
The USB diagnostic adapter, for instance, can be used for the communication between the PC
(including the »Engineer« software) and the controller, see the following illustration. The USB
diagnostic adapter is the connection between the PC (free USB port) and the controller (X6
diagnostic interface).
[2-3] Exemplary constellation for parameterising the controller
The All parameters tab in the »EASY Starter« and the »Engineer« provides a quick access to all
parameters of the controller.
The given categories and subcategories correspond 1:1 to the menus and submenus of the keypad:
[2-4] All parameters tab in the »Engineer«
Moreover, the »Engineer« provides a commissioning interface on the Application parameters tab
where you can commission the application in a few steps.
 Category
 Subcategories

Detailed information on how to handle the »Engineer« can be found in the integrated
online help that you can call with the [F1] function key.