Lenze 8400 StateLine - Manual (Page 439)

Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
439
9 Diagnostics & error management
9.6 Monitoring
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
9.6.3 AutoFailReset function
The AutoFailReset function serves to automatically reset the latching "Fault" and "TroubleQSP"
errors as well as the latching "WarningLocked" warning.
The "latching" term means that the effect on the controller remains active even after the error cause
has been removed.
To reset latching errors and warnings, the following options are available:
• Manual reset
• with device command C00002/19 (activated by Low-High edge)
• by a Low-High edge at the bResetFail input of the LS_DriveInterface (the "FailReset" control
bit in the control word must be parameterised with a value of "1").
• Automatic reset
• using the AutoFailReset function.
Overview of the relevant parameters
Parameter Info
C00184 Repetition time of the error reset processes
C00185 Time left until the next error reset process
C00186 Max. number of permissible unsuccessful error reset processes
• When the number set is reached, the response parameterised in C00189
is executed.
C00187 Current number of unsuccessful error reset processes carried out
C00188 Configuration of the AutoFailReset function
• 0: Off
• 1: Fault + TroubleQSP
• 2: WarningLocked
• 3: All locking
C00189 Response after max. number of unsuccessful error reset processes has been
reached
Highlighted in grey = display parameter