Lenze 8400 StateLine - Manual (Page 676)

15 Parameter reference
15.2 Parameter list | C00400
676
Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00400
C00401
Parameter | Name:
C00400 | LS_PulseGenerator
Data type: UNSIGNED_16
Index: 24175
d
= 5E6F
h
Time setting of the pulse to be output by the SB LS_PulseGenerator
Note:
The real length of the low or high level at the bSquareWave output is always 1 ms higher than set here in subcode
1 or 2. If "0 ms" is set, a level with a length of 1 ms is created length, for instance, and if "1000 ms" is set, a level with
a length of 1001 ms is created.
Setting range
(min. value | unit | max. value)
0 ms 60000
Subcodes Lenze setting Info
C00400/1 1000 ms Length of the low level (break) + 1 ms
C00400/2 1000 ms Length of the high level + 1 ms
C00400/3 100 ms From version 06.00.00
Delay time for status signal bFirstCycleDone
• The bFirstCycleDone status signal is set to TRUE when
the first task cycle is complete and the time set here
has expired.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00401 | CANxInOut: Inversion
Data type: UNSIGNED_16
Index: 24174
d
= 5E6E
h
From version 03.00.00
This parameter serves to invert the control/status bits of the CAN port blocks.
 CAN port block
Setting range
(min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded: Info
Bit 0 Active Bit set = bit is inverted
... ...
Bit 15 Active
Subcodes Lenze setting Info
C00401/1 0x0000 Inversion of LP_CanIn1.bCtrl1_B0...15
C00401/2 0x0000 Inversion of LP_CanOut1.bState1_B0...15
C00401/3 0x0000 Inversion of LP_CanIn2.bIn1_B0...15
C00401/4 0x0000 Inversion of LP_CanOut2.bOut1_B0...15
C00401/5 0x0000 Inversion of LP_CanIn3.bIn1_B0...15
C00401/6 0x0000 Inversion of LP_CanOut3.bOut1_B0...15
C00401/7 0x0000 Inversion of LP_CanIn4.bIn1_B0...15
• From version 15.00.00
C00401/8 0x0000 Inversion of LP_CanOut4.bOut1_B0...15
• From version 15.00.00
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT