Lenze 8400 StateLine - Manual (Page 764)

15 Parameter reference
15.2 Parameter list | C00915
764
Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00915
C00916
C00917
C00919
C00922
Parameter | Name:
C00915 | Motor cable length
Data type: UNSIGNED_16
Index: 23660
d
= 5C6C
h
From version 02.00.00
Single motor cable length for calculating the motor cable resistance
• The calculated motor cable resistance is displayed in C00917 .
Setting range (min. value | unit | max. value) Lenze setting
0.0 m 1000.0 5.0 m
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10
Parameter | Name:
C00916 | Motor cable cross-section
Data type: UNSIGNED_16
Index: 23659
d
= 5C6B
h
From version 02.00.00
Motor cable cross-section of a phase/cable for calculating the motor cable resistance
• The calculated motor cable resistance is displayed in C00917 .
Setting range (min. value | unit | max. value) Lenze setting
0.50 mm^2 100.00 6.00 mm^2
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00917 | Motor cable resistance
Data type: UNSIGNED_16
Index: 23658
d
= 5C6A
h
From version 02.00.00
Display of the motor cable resistance of a motor cable phase
• The motor cable resistance is calculated from the motor cable length set in C00915 and the motor cable cross-
section set in C00916 .
Display range (min. value | unit | max. value)
0 mOhm 64000
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00919 | Moment of inertia from load
Data type: UNSIGNED_32
Index: 23656
d
= 5C68
h
From version 12.00.00
In order to take account of mass inertias changing during the process (e.g. reels) when optimising the response to
setpoint changes, the maximum value of the changing moment of inertia must be set here. The process signal
nInertiaAdapt_a of the LS_MotorInterface SB can then be used in the process to dynamically control what
percentage of it is to be taken into account for the setpoint feedforward control.
Setting range
(min. value | unit | max. value)
0.00 kg cm^2 6000000.00
Subcodes Lenze setting Info
C00919/1 0.00 kg cm^2 Load moment of inertia
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00922 | ICM_DiagnosticCounter
Data type: UNSIGNED_16
Index: 23653
d
= 5C65
h
This code is for device-internal use only and must not be written to by the user!