Lenze E82xVxxxKxxxxx User Manual
Page 118
Advertising
Electrical installation
Basics for wiring according to EMC
Installation in the control cabinet
l
118
EDS82EV903 EN 3.0
Continuation of cable routing
Separation of the "hot" motor cable from the control, signal, and mains cables:
ƒ
Never install motor and signal cables in parallel and only cross at right angles
ƒ
The cables of a 24 V power supply unit (plus and minus cable) must be installed
closely together over their entire length in order that no loops may occur.
Fig. 6−5
Cable routing in the control cabinet
Advertising