Lenze E82xVxxxKxxxxx - Manual (Page 248)

Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Menu structure
9
l
248 EDS82EV903 EN 3.0
Description Submenus Main menu Description
Display No. Display No.
5.15 Vector−Ctrl 7 Operation with fieldbus function module on FIF (DRIVECOM
control)
Frequency setpoint via process data channel
5.15.1 FIF managem Fieldbus communication set−up
5.15.2 Freq setpt Frequency setpoint configuration
5.15.3 f limit/ramp Output frequency, acceleration time and deceleration time
configuration
5.15.4 Motor param Motor current control configuration, motor monitoring
5.15.5 Motor ident Identifying motor parameters
Sensorless torque control with speed limitation
5.16 Torque−Ctrl 0 Analog torque setpoint via analog input 1 (AIN1)
Speed limitation via maximum frequency C0011
5.16.1 Torque setpt Torque setpoint configuration
5.16.2 f limit Speed limitation configuration
5.16.3 Motor param Motor current control configuration, motor monitoring
5.16.4 Motor ident Identifying motor parameters
5.17 Torque−Ctrl 1 Analog torque setpoint via parameter channel (C0047)
Speed limitation via maximum frequency C0011
5.17.1 Torque setpt Torque setpoint configuration
5.17.2 f limit Speed limitation configuration
5.17.3 Motor param Motor current control configuration, motor monitoring
5.17.4 Motor ident Identifying motor parameters
5.18 Torque−Ctrl 2 Analog torque setpoint via analog input 1 (AIN1)
Analog speed limitation via analog input 2 (AIN2)
5.18.1 Torque setpt Torque setpoint configuration
5.18.2 f limit Speed limitation configuration
5.18.3 Motor param Motor current control configuration, motor monitoring
5.18.4 Motor ident Identifying motor parameters
5.19 Torque−Ctrl 3 Torque setpoint via AIF process data channel (AIF−IN.W1)
Speed limitation via maximum frequency C0011
5.19.1 Torque setpt Torque setpoint configuration
5.19.2 f limit Speed limitation configuration
5.19.3 Motor param Motor current control configuration, motor monitoring
5.19.4 Motor ident Identifying motor parameters
5.20 Torque−Ctrl 5 Operation with the system bus (CAN) function module on FIF
Torque setpoint via process data channel (CAN−IN1.W2)
Speed limitation via process data channel (CAN−IN1.W3)
5.20.1 CAN managem System bus (CAN) communication set−up
5.20.2 Torque setpt Torque setpoint configuration
5.20.3 f limit Speed limitation configuration
5.20.4 Motor param Motor current control configuration, motor monitoring
5.20.5 Motor ident Identifying motor parameters