Lenze E82xVxxxKxxxxx - Manual (Page 396)

Function library
Code table
10
l
396 EDS82EV903 EN 3.0
IMPORTANT Possible settings Code
Selection Lenze Name No.
C0138
* Process
controller
setpoint 1
(PCTRL1−SET1) 0.00 −650.00 {0.02
Hz}
650.00 The set value will be lost during
mains switching!
l Selection if C0412/4 =
FIXED−FREE
l Display if C0412/4 ¹
FIXED−FREE
^ 322
C0140
* Additive
frequency
setpoint
(NSET1−NADD) 0.00 −650.00 {0.02
Hz}
650.00 l Selection via j function of
the keypad or parameter
channel
l Acts additively on the main
setpoint
l Value will be stored when
switching the mains or
removing the keypad
l C0140 is only transferred
during parameter set transfer
with GDC (not with keypad)
^ 311
C0141
* Scaled setpoint 0.00 −100.00 {0.01 %} 100.00 The set value will be lost during
mains switching!
Only effective if C0127 = 1
Based on C0011
C0142
v
Starting
condition 1 0 Automatic start is inhibited after
mains connection
Flying restart circuit inactive Start after HIGH−LOW−HIGH level
change at X3/28 ^ 275
1 Automatic start if X3/28 = HIGH
Flying restart circuit inactive
2 Automatic start is inhibited after
mains connection
Flying restart circuit active Start after HIGH−LOW−HIGH level
change at X3/28
3 Automatic start if X3/28 = HIGH
Flying restart circuit active
C0143
*
v
Selection of
flying restart
mode 0 0 Max. output frequency (C0011) ... 0 Hz Motor speed is searched for in the
stated range ^ 275
1 Last output frequency ... 0 Hz
2 Connect frequency setpoint
(NSET1−NOUT) The respective value is connected
after the controller enable
3 Connect actual process controller value
(C0412/5) (PCTRL1−ACT)
C0144
v
Temperature−d
ependent
reduction of
the switching
frequency 1 0 No temperature−dependent reduction
of the switching frequency During operation at a switching
frequency of 16 kHz the frequency
is also reduced to 4 kHz. This
behaviour can be changed in
C0310.
^ 270
1 Automatic reduction of the switching
frequency to 4 kHz if
J reaches
max. − 5 °C