Lenze E82xVxxxKxxxxx - Manual (Page 216)

Commissioning
Important codes for quick commissioning
8
l
216 EDS82EV903 EN 3.0
IMPORTANT Possible settings Code
Selection Lenze Name No.
C0002
*
s
uSEr
(Cont.)
Transferring
parameter sets
with the
keypad Keypad ð PAR1 (+ FPAR1) Overwrite selected parameter set
and, if required FPAR1, with the
corresponding data of the keypad
71 with function module application I/O,
INTERBUS, PROFIBUS−DP, LECOM−B,
DeviceNet/CANopen
11 with all other function modules
Keypad
ð PAR2 (+ FPAR1)
72 with function module application I/O,
INTERBUS, PROFIBUS−DP, LECOM−B,
DeviceNet/CANopen
12 with all other function modules
Keypad
ð PAR3 (+ FPAR1)
73 with function module application I/O,
INTERBUS, PROFIBUS−DP, LECOM−B,
DeviceNet/CANopen
13 with all other function modules
Keypad
ð PAR4 (+ FPAR1)
74 with function module application I/O,
INTERBUS, PROFIBUS−DP, LECOM−B,
DeviceNet/CANopen
14 with all other function modules
Controller
ð keypad Copy all available parameter sets
(PAR1 ... PAR4, if required FPAR1)
into the keypad
80 with function module application I/O,
INTERBUS, PROFIBUS−DP, LECOM−B,
DeviceNet/CANopen
20 with all other function modules
Keypad
ð function module Only overwrite the
module−specific parameter set
FPAR1 with the data of the keypad
40 only with function module INTERBUS,
PROFIBUS−DP, LECOM−B,
DeviceNet/CANopen
Function module ð keypad Only copy the module−specific
parameter set FPAR1 into the
keypad
50 only with function module INTERBUS,
PROFIBUS−DP, LECOM−B,
DeviceNet/CANopen
C0002
*
s
uSEr
(Cont.)
Saving your
own basic
setting 9 PAR1 ð own basic setting For the parameters of the
controller you can save an own
basic setting (e.g. the delivery
status of your machine):
1. Ensure that parameter set 1 is
active
2. Inhibit controller
3. Set C0003 = 3, confirm with
v
4. Set C0002 = 9, confirm with
v, the own basic setting is
saved
5. Set C0003 = 1, confirm with
v
6. Enable the controller
C0002
*
s
uSEr
(Cont.)
Loading/copyin
g the own basic
setting By using this function you can also
just copy PAR1 into the parameter
sets PAR2 ... PAR4
5 own basic setting ð PAR1 Restore own basic setting in the
parameter set selected
6 own basic setting ð PAR2
7 own basic setting ð PAR3
8 own basic setting ð PAR4