Lenze E82xVxxxKxxxxx - Manual (Page 341)

Function library
Free interconnection of analog signals
Free configuration of analog process data output words
10
l
341 EDS82EV903 EN 3.0
IMPORTANT Possible settings Code
Selection Lenze Name No.
C0421
*
v
(Cont.)
Possible analog signals for C0421 ^ 338
26 Output frequency normalised without
slip (MCTRL1−NOUT−NORM) 2 14 º C0011
27 Output frequency without slip
(MCTRL1−NOUT) 24000 º 480 Hz
28 Actual process controller value
(PCTRL1−ACT)
29 Process controller setpoint
(PCTRL1−SET1)
30 Process controller output without
feedforward control (PCTRL1−OUT)
31 Ramp function generator input
(NSET1−RFG1−IN)
32 Ramp function generator output
(NSET1−NOUT)
33 (A) PID controller output
(PCTRL1−PID−OUT)
34 (A) Process controller output
(PCTRL1−NOUT)
35 Input signal at X3/8 (standard I/O) or
X3/1U or X3/1I (application I/O),
assessed with gain (C0414/1 or C0027)
and offset (C0413/1 or C0026)
(AIN1−OUT) 1000 º Maximum value of analog
input signal (5 V, 10 V, 20 mA, 10
kHz)
Condition: The gain of the analog
input or frequency input is set to:
C0414/x, C0426 = 20/C0011 [%]
36 Input signal at frequency input X3/E1,
assessed with gain (C0426) and offset
(C0427) (DFIN1−OUT)
37 Motor potentiometer output
(MPOT1−OUT)
38 (A) Input signal at X3/2U or X3/2I,
assessed with gain (C0414/2) and
offset (C0413/2) (AIN2−OUT)
40 AIF input word 1 (AIF−IN.W1) Setpoints to the controller from
communication module on AIF
Normalisation via AIF
41 AIF input word 2 (AIF−IN.W2)
50 CAN−IN1.W1 or FIF−IN.W1 Setpoints to controller from
function module on FIF
Normalisation via CAN or FIF
51 CAN−IN1.W2 or FIF−IN.W2
52 CAN−IN1.W3 or FIF−IN.W3
53 CAN−IN1.W4 or FIF−IN.W4
60 CAN−IN2.W1
61 CAN−IN2.W2
62 CAN−IN2.W3
63 CAN−IN2.W4
255 Not assigned (FIXED−FREE)
Signal linkage
The process data output words are linked with internal analog signals by entering the
selection figure of the internal signal in the corresponding subcode of C0421. C0421 can
be different for the parameter sets.