Lenze E82xVxxxKxxxxx - Manual (Page 428)

Function library
Code table
10
l
428 EDS82EV903 EN 3.0
IMPORTANT Possible settings Code
Selection Lenze Name No.
C0421
*
v
(Cont.)
Possible analog signals for C0421 ^ 338
26 Output frequency normalised without
slip (MCTRL1−NOUT−NORM) 2 14 º C0011
27 Output frequency without slip
(MCTRL1−NOUT) 24000 º 480 Hz
28 Actual process controller value
(PCTRL1−ACT)
29 Process controller setpoint
(PCTRL1−SET1)
30 Process controller output without
feedforward control (PCTRL1−OUT)
31 Ramp function generator input
(NSET1−RFG1−IN)
32 Ramp function generator output
(NSET1−NOUT)
33 (A) PID controller output
(PCTRL1−PID−OUT)
34 (A) Process controller output
(PCTRL1−NOUT)
35 Input signal at X3/8 (standard I/O) or
X3/1U or X3/1I (application I/O),
assessed with gain (C0414/1 or C0027)
and offset (C0413/1 or C0026)
(AIN1−OUT) 1000 º Maximum value of analog
input signal (5 V, 10 V, 20 mA, 10
kHz)
Condition: The gain of the analog
input or frequency input is set to:
C0414/x, C0426 = 20/C0011 [%]
36 Input signal at frequency input X3/E1,
assessed with gain (C0426) and offset
(C0427) (DFIN1−OUT)
37 Motor potentiometer output
(MPOT1−OUT)
38 (A) Input signal at X3/2U or X3/2I,
assessed with gain (C0414/2) and
offset (C0413/2) (AIN2−OUT)
40 AIF input word 1 (AIF−IN.W1) Setpoints to the controller from
communication module on AIF
Normalisation via AIF
41 AIF input word 2 (AIF−IN.W2)
50 CAN−IN1.W1 or FIF−IN.W1 Setpoints to controller from
function module on FIF
Normalisation via CAN or FIF
51 CAN−IN1.W2 or FIF−IN.W2
52 CAN−IN1.W3 or FIF−IN.W3
53 CAN−IN1.W4 or FIF−IN.W4
60 CAN−IN2.W1
61 CAN−IN2.W2
62 CAN−IN2.W3
63 CAN−IN2.W4
255 Not assigned (FIXED−FREE)
C0422
* Offset for
analog output
X3/62 (AOUT1−
OFFSET)
Standard I/O 0.00 −10.00 {0.01 V} 10.00 C0422 and C0109 are equal ^ 332
C0422
*
(A) Offset of
analog outputs
Application I/O −10.00 {0.01 V} 10.00
^ 332
1 X3/62 (AOUT1−
OFFSET)
0.00 C0422/1 and C0109 are the same
2 X3/63 (AOUT2−
OFFSET)