Lenze E82xVxxxKxxxxx - Manual (Page 249)

Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Menu structure
9
l
249 EDS82EV903 EN 3.0
Description Submenus Main menu Description
Display No. Display No.
5.21 Torque−Ctrl 7 Operation with fieldbus function module on FIF (DRIVECOM
control)
Torque setpoint via process data channel
Speed limitation via process data channel
5.21.1 FIF managem Fieldbus communication set−up
5.21.2 Torque setpt Torque setpoint configuration
5.21.3 f limit Speed limitation configuration
5.21.4 Motor param Motor current control configuration, motor monitoring
5.21.5 Motor ident Identifying motor parameters
Process control with PID controller in the "V/f characteristic control" operating mode
5.22 PID−Ctrl 0 Setpoint via parameter channel (C0181)
Analog actual value via analog input 1 (AIN1)
5.22.1 Setpoint Setpoint configuration
5.22.2 Actual value Actual value configuration
5.22.3 PCTRL setup Process controller configuration
5.22.4 f limit/ramp Output frequency, acceleration time and deceleration time
configuration
5.22.5 Motor param Motor current control configuration, motor monitoring
5.23 PID−Ctrl 1 Setpoint via parameter channel (C0138)
Analog actual value via analog input 1 (AIN1)
5.23.1 Setpoint Setpoint configuration
5.23.2 Actual value Actual value configuration
5.23.3 PCTRL setup Process controller configuration
5.23.4 f limit/ramp Output frequency, acceleration time and deceleration time
configuration
5.23.5 Motor param Motor current control configuration, motor monitoring
5.24 PID−Ctrl 2 Analog setpoint via analog input 1 (AIN1)
Analog actual value via analog input 2 (AIN2)
5.24.1 Setpoint Setpoint configuration
5.24.2 Actual value Actual value configuration
5.24.3 PCTRL setup Process controller configuration
5.24.4 f limit/ramp Output frequency, acceleration time and deceleration time
configuration
5.24.5 Motor param Motor current control configuration, motor monitoring
5.25 PID−Ctrl 3 Setpoint via AIF process data channel (AIF−IN.W1)
Analog actual value via analog input 1 (AIN1)
5.25.1 Setpoint Setpoint configuration
5.25.2 Actual value Actual value configuration
5.25.3 PCTRL setup Process controller configuration
5.25.4 f limit/ramp Output frequency, acceleration time and deceleration time
configuration
5.25.5 Motor param Motor current control configuration, motor monitoring