Lenze E82xVxxxKxxxxx - Manual (Page 251)

Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Menu structure
9
l
251 EDS82EV903 EN 3.0
Description Submenus Main menu Description
Display No. Display No.
10 Terminal I/O Linking of inputs and outputs to internal signals and display of
signal levels at the terminals
The type and the equipment of the controller determine the
submenus that are displayed.
10.1 AIN1 Analog input 1
10.2 AIN2 Analog input 2
10.3 AOUT1 Analog output 1
10.4 AOUT2 Analog output 2
10.5 DIGIN1/PTC Digital inputs and PTC input
10.6 RELAY1 Relay output 1
10.7 RELAY2 Relay output 2
10.8 DIGOUT1 Digital output 1
10.9 DIGOUT2 Digital output 2
10.10 DFIN1 Frequency input
10.11 DFOUT1 Frequency output
10.12 MPOT1 Motor potentiometer function
Only active with standard devices from software version 2.2:
Change to the code level to display the levels at the terminals. The values of the levels of
the analog inputs and outputs are offset and gain.
10.13 Monit AIN1 Level at analog input 1
0 ... 100 % (based on C0034)
10.14 Monit AIN2 Level at analog input 2
0 ... 100 % (based on C0034)
10.15 Monit AOUT1 Level at analog output 1
0 ... 100 %
(basis for standard I/O: 10 V)
(basis for application I/O: C0424)
10.16 Monit AOUT2 Level at analog output 2
0 ... 100 % (based on C0424)
10.17 Monit PTC Status of the PTC input
0
º open, 1 º closed
10.18 Monit DIGIN Status of the digital inputs and the input for controller inhibit
X3/28
0
º LOW, 1 º HIGH
10.19 Monit DIGOUT Status of the digital outputs and status of the NO contact of
the relay outputs:
0
º LOW, 1 º HIGH
11 LECOM/AIF Configuration of operation with communication modules
11.1 LECOM setup Serial interface
11.2 AIF setup Process data
11.3 Status words Display of status words