Lenze E82xVxxxKxxxxx - Manual (Page 373)

Function library
Individual summary of drive parameters in the user menu
10
l
373 EDS82EV903 EN 3.0
10.17 Individual summary of drive parameters in the user menu
Description
ƒ Quick access to ten selected codes via the user menu of the keypad
ƒ With password protection, an individual code selection can be prepared which can
only be changed by e.g. your operating personnel.
Codes for parameter setting
Code Possible settings IMPORTANT
No. Name Lenze Selection
C0517
*
v
User menu l After mains switching or in the
g function the code from
C0517/1 is displayed.
l In the Lenze setting the user
menu contains the most
important codes for
commissioning the operating
mode "V/f characteristic control
with a linear characteristic"
l If the password protection is
active, only the codes entered
in C0517 can be freely accessed
l If less than 10 codes are
required, assign the value "0"
(zero) to the memory locations
not used. Please observe that
the software automatically
assigns code C0050 to a
memory location that is not
used, if it has not been
explicitly assigned to another
memory location.
^ 373
1 Memory 1 50 C0050 Output frequency (MCTRL1−NOUT)
2 Memory 2 34 C0034 Range of analog setpoint selection
3 Memory 3 7 C0007 Fixed configuration of digital input
signals
4 Memory 4 10 C0010 Minimum output frequency
5 Memory 5 11 C0011 Maximum output frequency
6 Memory 6 12 C0012 Acceleration time main setpoint
7 Memory 7 13 C0013 Deceleration time main setpoint
8 Memory 8 15 C0015 V/f rated frequency
9 Memory 9 16 C0016 V
min
boost
10 Memory 10 2 C0002 Parameter set transfer
Possible entries for C0517
xxxx All codes apart from the codes labelled
with "(A)". Syntax:
Codes: C0517/x = cccc
Subcodes: C0517/x = cccc.ss
Adapt the user menu
Enter the desired code numbers or subcode numbers into the subcodes of C0517.